|
|
T
|
Name
|
Size
|
Created / Uploaded
|
Last modified
|
Files
|
Hits
|
|
|
|
|
|
Wrtailwheelmnt4
The carbon is now trimmed arounf the sides and the wheel well hole trimmed to match the hole in the rubber (which is uneven and off centre).
A trial fit shows the wheel fits ok. These wheel bearings take a 8mm shaft, I also have some which take 6mm.
|
74.95 KB |
Sat 26 of Apr, 2008 01:25 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
86 |
|
|
|
|
|
Wrtailwheelmnt3
I cleaned up the block and tidied up the slot where the axle goes.
The I made a vacuum infuse carbon fibre cap.
Vacuum infusion info can be found on my main webside - eddie.com |
66.26 KB |
Sat 26 of Apr, 2008 01:25 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
83 |
|
|
|
|
|
Wrtailwheelmnt2
Our broken tailwheel mounting block for VH-GWR. This side is glued to the tailboom
Appears to be made of poly-urethane rubber (not foam) - black glue is probably sicaflex.
The white is gelcoat.
There is a steel frame thingy encased in the mount. This lets a roller-blade wheel be fitted but one side has broken off.
|
36.54 KB |
Mon 21 of Apr, 2008 02:19 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
88 |
|
|
|
|
|
Wrtailwheelmnt
This is the side which sees the runway. The steel axle mounting hole is intact on the bottom side of the photo but the other side is broken. |
29.34 KB |
Mon 21 of Apr, 2008 02:20 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
85 |
|
|
|
|
|
Wrdollywheel
|
112.00 KB |
Mon 21 of Apr, 2008 02:19 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
84 |
|
|
|
|
|
Throtholder1 Red
|
69.45 KB |
Sun 08 of Dec, 2013 02:22 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
237 |
|
|
|
|
|
Quad1
|
153.74 KB |
Mon 11 of Nov, 2013 11:14 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
197 |
|
|
|
|
|
Ppgguagemount
|
204.85 KB |
Sun 17 of Nov, 2013 10:08 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
228 |
|
|
|
|
|
Ppg Guages
|
47.71 KB |
Mon 11 of Nov, 2013 11:14 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
201 |
|
|
|
|
|
Perv3
|
69.05 KB |
Sun 13 of Apr, 2008 18:23 UTC |
Fri 25 of Jul, 2025 06:20 UTC |
|
92 |
|
|